Drag Lowering Springs Set
with Minimal Drop
for Ford Mustang 5.0L GT 2015-23 & 2024+

Manufactured by BMR Suspension | Part #SPD763R

Give your S550 and S650 Mustang an aggressive look with a set of Lowering Springs from BMR Suspension! 

Stock springs can sag, get rusty, and simply wear out over a long period of time. BMR’s Drag Lowering Springs (SPD763) provide a minimum drop in the front of your Mustang and are designed for street performance and drag racing applications. When performance is a must, rely on BMR Suspension!

Features:

•  Designed for V8 boosted (super/turbocharged) applications where there is an increase in weight over the front suspension
• Manufactured from chrome silicon high-tensile spring wire
• 170 lb/in (Front) and 740 lb/in (Rear) linear spring rate
• Cold-wound on a CNC coiling machine to exact specifications
• Stress-relieved at 750 degrees Fahrenheit
• Shot-peened
• Computer tested for accurate height and spring rate
• Provides a minimum drop in the front with SP089
• Improves launch characteristics at the dragstrip
• Lifetime warranty against spring sag
• Red powder coat for long lasting finish and good looks
• Proudly designed & manufactured in the USA!
  

Installation:

• Installation time is about 3-4 hours.
• Suitable for factory shocks and struts that are in good condition.
• Designed to work with OE mounts and perches or Camber Plates that re-use the OE perch. Aftermarket perches (Vorshlag) may not fit properly and could lead to excessive NVH (Noise Vibration and Harshness).
• Due to the lowered ride height, the OE bump stops must be shortened.
• Lowering springs will increase negative camber. To prevent premature tyre wear, a 4 wheel alignment is recommended after any spring installation.

Vehicle Applications:

• Ford Mustang S550 - 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
• Ford Mustang S650 - 2024+
• Designed for 5.0L Models with a Supercharger or Turbo charger installed.
• Not suitable for 2018+ Mustangs equipped with Magneride.